Toshiba VP 300, Installation Instructions Manual

Page: 230 / 614

Toshiba VP Systems Release 7.1 July, 1994
5-72 Installation and Maintenance Manual
Table 5-3 Hardware Error Types and Remedies (continued)
Error Type:Name Source Remedy Priority
42: Configuration
Error
Error detected in the
configuration tables Check the configuration tables. 0
The DATA-1 field specifies the type of error. DATA-2 through DATA-4 are data
associated with the error.
43: Hard Disk/
Language Table
Read/Write Error
Error detected in the
read/write of
language table Errors 1 or 3 — Run FLOPPY Backup/
Restore.
Errors 2, 5, 6, 7, or 8 — Run Disk
EXerciser command. 3
01 = NO LANGUAGE LOADED
02 = NO ACTIVE SYSTEM DISKS FOR READ
03 = CK SUM ERROR ON READ
04 = TABLE SIZE ERR
05 = CAN’T READ EITHER SYS-DISK
06 = ERR ON WRITE TO DISK #1
07 = ERR ON WRITE TO DISK #2
08 = ERR ON WRITE TO BOTH DISKS
09 = LANGUAGE QTY LOADED EXCEEDS OCC MAX
DATA-1 =
DATA-1 = ERROR CODE:
01 =
02 =
03 =
04 =
05 =
06 =
07 =
NO DEFAULT LINK ASSIGNED FOR NON-SPECIFIED COS
DATA-2 = COS
DATA-3 = HIGH BYTE OF USER NUMBER
DATA-4 = LOW BYTE OF USER NUMBER
NON-FATAL ERROR, DRIVE 2
DATA-2 = DEFAULT LINK ASSIGNED (SEE NOTE 1)
DATA-3 = THIS DEFAULT LINK (SEE NOTE 1)
NON-FATAL ERROR, DRIVE 3
DATA-2 = SYSTEM PORT NUMBER
DATA-3 = FIRST IU TASK ASSIGNED (1…)
DATA-4 = THIS IU TASK ASSIGNED (1…)
AP NOT CONFIGURED IN SLOT TABLE BUT SYSP 146 IS SET
LINK ASSIGNED FOR MWI WAS NOT ENABLED
DATA-2 = LINK AND UNIT (SEE NOTE 1)
DATA-3 = HI BYTE OF USER NUMBER
DATA-4 = LO BYTE OF USER NUMBER
GATEWAY ERROR MBOX NOT CONFIGURED (SYSP 199)
CALL TO MBOX WITH COS ATTRIBUTE 84 THAT WAS NOT
CORRECTLY CONFIGURED
DATA-2 = SPECIFIC OUTFAX (Attribute 84) ERROR
= 0 = MBOX HAS ZERO MESSAGES
Note 1: HB NIB = LINK (0…); LO NIB = IU (1…)
ERROR CODE, AS FOLLOWS: