Toshiba VP 300, Installation Instructions Manual

Page: 241 / 614

4. Disengage the integration card from the Motherboard by pivoting the plastic
card ejectors on the top and bottom of the PCA front edge.
5. Slide the integration card out of the card cage, handling the LIC only by the
top and bottom edges. Do not touch components on the card.
6. Store removed integration card in a static protection bag.
Installing Integration
Installation of the integration card is as follows:
Cards
1. Put on antistatic wrist strap. Connect it to the unpainted portion of the
cabinet.
2. While holding top and bottom edges, slide the integration card into the card
cage.
3. Pivot the card ejectors as needed to grip small flanges on the front edges of
the card cage.
4. Firmly seat the integration connectors into the Motherboard by pressing
ejectors against the front edge of the card. The ejectors clips onto small pins
on the integration card when the connectors have seated.
◆
WARNING
◆
Do not slam the integration card into the cabinet, as this may
damage the board or motherboard connectors.
Once the integration card is installed, the red LED comes ON. When selftest
diagnostics are complete, the green LED comes ON. When the card has been
initialized and is ready for operation, the red LED goes OFF (which takes
place in less than five minutes).
5. Initialize the integration card by entering:
CUINTG x y
where x is the slot number and y is the unit number.
6. If there are two units, both units would have to be initialized.
Repeat this step for unit 2.
7. Test the system for proper operation.
■
Fax Application Processor (Release 7.1 and later)
The VP 300 fax application processors (fax cards) installed in Shelf A are designed to be hot plugged;
that is, the system does not need to be powered down to remove or install the cards. See Figure 5-8.
Toshiba VP Systems Release 7.1 July, 1994
MAINTENANCE
5-83