Toshiba VP 300, Installation Instructions Manual

Page: 365 / 614

Action VP 300 Description and Response
If any diskette fails the test, a replacement must be obtained before
continuing with this procedure. Refer to MAINTENANCE, Floppy
Disk Drive (FD) Diagnostics section, for a description of this
diagnostic.
13. Repeat steps 11 and 12
for each diskette.
Choose the Correct Disk
Option
14. Insert the Release 5
Software Diskette #1
into the FD.
15. @DSKTST At the @ prompt enter the slot number for the restored drive. The VCU
tests the slot and updates its status record.
Repeat DSKTST for each drive restored.
16. @DISKO The following menu is presented:
17. Choose option 4 — The following is then presented:
RESTORE SYSTEM.
18. Enter the number of After several seconds the VP 300 displays:
drives in your system.
RESTORE IS COMPLETE.
REFER TO HARD DISK PROCEDURES (RESTORE).
:4
Enter number of drives
(1 – 6, Empty line = EXIT)
:
CURRENT STATUS
Slot Type ID Status Configured
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
B3 System1 S1 ACTIVE Configured
B4 System2 S2 EMPTY Configured
C1 Voice1 – – EMPTY Not Configured
C2 Voice2 – – EMPTY Not Configured
C3 Voice3 – – EMPTY Not Configured
C4 Voice4 – – EMPTY Not Configured
DISK OPTIONS
1. ADD DISK
2. REMOVE DISK
3. REPLACE A DISK
4. RESTORE SYSTEM
Select option to be performed
(1–5, – Empty line = EXIT)
:
Enter
Enter
Toshiba VP Systems Release 7.1 July, 1994
PROCEDURES
6-51