Toshiba VP 300, Installation Instructions Manual

Page: 371 / 614

■
Hard Disk Restore for Release 6.1 and Later
These procedures provide the steps to restore a system where the:
•
The VP 300 is configured as a one-disk system and the hard disk needs replacement.
•
The VP 300 is configured as a multiple-disk system and both of the system disks need
replacement.
☞
When doing the Hard Disk Restore procedures, make sure that the diskettes being used are for
the correct release level.
Action VP 300 Description and Response
Preparation Back up greetings, names, scripted and sequential messages, and
Personal Distribution List names.
Refer to the Backup and Restore of Greetings, Names, Scripted and
Sequential Messages, personal Distribution List Names, and Prompts
section in this chapter.
Replace the Hard
Disk
1. Forward ports.
2. Remove the hard disk(s) Hard disks may be hot plugged.
to be replaced.
3. Install the replacement Refer to the MAINTENANCE chapter, Hard Disk Drive (HD)
hard disk(s). Replacement, for Hard Disk Replacement procedures. Hard disks may
be hot plugged.
Boot the System
4. Make sure the Software
Diskette #1 (for the
correct release level) is
write-protected.
5. Insert Software Diskette
#1 (for the correct
release level) into the
Floppy Drive (FD).
6. Adjust the baud rate
of the terminal/
teleprinter to 300,
1200, or 9600 baud.
Toshiba VP Systems Release 7.1 July, 1994
PROCEDURES
6-57