Toshiba VP 300, Installation Instructions Manual

Page: 509 / 614

Option Number and Name Setting
36 —Call Forwarding – Follow Me ENABLED
38 — Never a Forwardee ENABLED
41 — Data Security ENABLED
42 — Station Override Security ENABLED
44 — Originate Only ENABLED
78 — Do Not Disturb ENABLED
106 — SUPERSET Sub-Attendant ENABLED
All other COS options must be disabled.
3. (CPI only) Allocate an unused PBX COS for the MIC call processing ports. Assign this
COS only to the MIC call processing ports, and not to any other extensions. Using the
console in program mode, assign the COS options listed below. Also assign any options the
VP 300 requires for use of external trunks, such a Trunk Group Access options or ARS
options.
Assign this class of service option to the call processing port only if not using the COV
Voice Mail port message waiting indication:
Option Number and Name Setting
34 — Call Forwarding – Busy ENABLED
35 — Call Forwarding – Don’t Answer ENABLED
36 — Call Forwarding – Follow Me ENABLED
41 — Data Security ENABLED
42 — Station Override Security ENABLED
78 — Room Do Not Disturb Enable ENABLED
All other COS options must be disabled.
4. Put the console in extended programming mode to configure the MIC Superset extensions
and proceed as follows:
•
(MWI only) Allocate a Superset extension to be used for controlling message waiting
indicators. Assign this extension the COS defined for MWI in step 2 above. This
extension cannot be used to answer calls.
•
Allocate the Superset extensions to be used for call processing. Assign these
extensions the COS defined for CPI in step 3 above.
When the Superset extnsions have been programmed, exit from extended programming
mode to assign the CPI extensions to a hunt group.
5. Create a hunt group that includes all of the MIC port extensions used for CPI. If this is an
upgrade of an installed VP 300, use the existing VP 300 port hunt group, but include only
the CPI extensions as hunt group members. Otherwise, allocate a new hunt group. Program
the hunt group as follows:
•
Allocate a convenient access number that will be used to call the VP 300 system and
enter it as the hunt group access code.
•
Enter the equipment numbers of the CPI Superset extensions as members of the hunt
group. Re-enter the first equipment number as the last quipment number, so that the
hunt group is circular.
Toshiba VP Systems Release 6.1 February, 1993
MITEL SX-100/SX-200 ANALOG ADAPTIVE INTEGRATION 10.2-13