Toshiba VP 300, Installation Instructions Manual

Page: 214 / 614

Toshiba VP Systems Release 7.1 July, 1994
5-56 Installation and Maintenance Manual
Table 5-3 Hardware Error Types and Remedies
Error Type:Name Source Remedy Priority
1: Floppy TEST FLOP 1 or while
trying to read. Clear Hardware Error Table and run TE
F 1. If error repeats, replace the
following components one at a time.
Run TE F 1 each time. Check cables,
diskette, CPU, MFD. 1
2: Tone Reflection Clear Hardware Error Table. Run TE
L 1. If one channel fails, disconnect line
cord and run TE L 1 again or TE L 5. If
errors repeat, replace the LIC. If all lines
fail, check the configuration or VCU as
possible cause. 2
3: Prompt Same as error 2. 2
5: Ring Through Verify extension numbers in the Table
are correct. Could be a problem in PBX
extensions or LIC. 2
6: Floppy Disk
Controller Clear Hardware Error Table, run TEST
FLOP 1. Check cables. If errors repeat,
replace CPU. 1
Same as error 2. 2 4: DTMF Reflection
On-line diagnostic
tests Replace VCU. Re-boot the system. If
error repeats, replace CPU. If problem
continues, contact Toshiba Technical 3 8: VCU On-line
Error
Disk message
capacity is all used up For DATA-1=03 and DATA-2=00-06,
& 11 errors, erase messages or increase
hard disk capacity. For DATA-2=10
errors, call Toshiba Technical Support. 10: Disk is getting
Full
3
DATA1 =
DATA2 =
DATA-3 =
DATA-4 =
03
00
01-06
10
11
NOT USED
NOT USED
=
=
=
=
= Disk full or cannot make message redundant
No voice file slots left
Logical drive ID that is full
Prompt area full
No disk with sufficient space available
Selftest or TEST
LINE 1, TEST L 5
Selftest or TEST
LINE 1
Selftest or TEST
LINE 1
TEST LINE 2 PORT
During read or write
to Floppy
Support.