Toshiba VP 300, Installation Instructions Manual

Page: 510 / 614

■
Trunks and Trunk Groups
With the console in programming mode, configure any trunks that are to be answered by the VP
300. Each individual trunk must have its own entry in the VP 300 TRUNK GROUP Table.
Configure each trunk as follows:
1. Set the answer points for DAY, NIGHT 1, and NIGHT 2 service to the MIC port hunt
group number according to when the trunk is to be answered by the VP 300.
2. Note the trunk number so that this number may be entered in the VP 300 TRUNK GROUP
Table.
■
Station Extensions
Certain COS options in the PBX may need to be enabled for individual employees so that they
can access the Adaptive Integration features. The features, and their associated COS options,
are described below.
•
In order to use Adaptive Integration for secondary answering of internal calls, employees
must be able to forward their phones to the MIC port hunt group. This requires that they be
assigned a COS with one or more of the following COS options enabled:
34 — Call Forwarding – Busy
35 — Call Forwarding – Don’t Answer
36 — Call Forwarding – Follow Me
☞
Forwarding is enabled or disabled, by mailbox holders, by means of feature access
codes, at the station itself. It is the responsibility of each individual to turn their
forwarding ON or OFF as the application requires.
For extensions using MWI, only the use of Call Forwardng – Don’t Answer is
recommended, because when a phone forwards immediately, the VP 300 cannot turn that
phone’s message waiting indicator ON or OFF. Refer to Mitel SX-100/SX-200 Analog
Limitations and Applications, in this section.
•
Operation of MWI requires that stations with message waiting indicators be assigned a
COS with COS Option 77, MESSAGE WAITING APPLIES, enabled. Stations that do not
have message waiting indicators must not be assigned COS option 77.
☞
Stations that are to have message waiting indicators controlled by the VP 300 must
be connected to line cards in the Mitel SX-100/SX-200 Analog that support message
waiting lamps.
Obtain a printout of station extensions that includes each station’s assigned COS and a
printout of all COS that have been assigned to station extensions. Use this information to
check that mailbox holders are assigned the COS options necessary to use the features
described above.
Toshiba VP Systems Release 6.1 February, 1993
10.2-14 Installation and Maintenance Manual