Mitsubishi Electric fr-e700 series, Instruction Manual

Page: 30 / 608

Mounting Installation
2 - 6
The inverter consists of precision mechanical and electronic parts. Never install or handle it in any of
the following conditions as doing so could cause an operation fault or failure.
NOTE
When encasing multiple inverters, install them in parallel as a cooling measure. Leave enough
clearances around the inverter (refer to page 2-11).
Fig. 2-8:
Good heat dissipation is achieved through the
vertical alignment of the frequency inverter, the
side-by-side mounting and maintenance of
minimum clearances.
I002151E
I001708E
Fig. 2-9: Conditions that could cause an operation fault or failure
Refer to Fig. 2-10 f
or the
clearances
V
er
tical
Direct sunlight Vibration ( 5.9 m/s²)
High temperature,
high humidity
Horizontal placement
(When mounted inside enclosure.) Transportation by holding
the front cover or dial
Oil mist, flammable gas,
corrosive gas, fluff, dust, etc.
Mounting to
combustible material