Mitsubishi Electric fr-e700 series, Instruction Manual

Page: 454 / 608

Special operation Parameter
6 - 300
햲
When the X14 signal is not assigned, only the Pr. 128 setting makes PID control valid.
햳
The half-tone screened areas indicate the parameter initial values.
햴
Refer to the CC-Link communication option (FR-A7NC-Ekit-SC-E) instruction manual for the set-
ting method from CC-Link communication.
Refer to the LONWORKS communication option (FR-A7NL-Ekit-SC-E) instruction manual for the
setting method from LONWORKS communication.
햵
When "100" or larger value is set to any of Pr. 190 to Pr. 192 "Output terminal function selection",
the terminal output has negative logic. (Refer to section 6.10.5 for details.)
햶
If Pr. 133 is used for the set point signal (setting 9999) any additional set point signal applied to
terminals 2-5 will be ignored.
Output
FUP
Depending
on
Pr. 190–192
Upper limit out-
put Output to indicate that the measured
value signal exceeded the upper limit
value (Pr. 131). Pr. 128 = 20, 21, 60, 61
Pr. 131
9999
Set "15" or "115" to any of
Pr. 190–Pr. 192.
햵
FDN
Lower limit out-
put Output when the measured value
signal falls below the lower limit (Pr.
132). Pr. 128 = 20, 21, 60, 61
Pr. 132
9999
Set "14" or "114" to any of
Pr. 190–Pr. 192.
햵
RL
Forward
(reverse) rota-
tion direction
output "Hi" is output to indicate that the out-
put indication of the parameter unit
is forward rotation (FWD) or "Low" to
indicate that it is reverse rotation
(REV) or stop (STOP).
Set "16" or "116" to any of
Pr. 190–Pr. 192.
햵
PID
During PID con-
trol
activated Turns on during PID control. Set "47" or "147" to any of
Pr. 190–Pr. 192.
햵
SE SE
Output
terminal
common Common terminal for open collector
output terminal.
NOTES
Changing the terminal function using any of Pr. 178 to Pr. 184 and Pr. 190 to Pr. 192 may affect the
other functions. Make setting after confirming the function of each terminal.
When the Pr. 267 setting was changed, check the voltage/current input switch setting. Different
setting may cause a fault, failure or malfunction. (Refer to page 6-178 for setting.)
Signal
Terminal
Used
Function Description Parameter Setting
Tab. 6-113: I/O signals and parameter settings (2)