Mitsubishi Electric fr-e700 series, Instruction Manual

Page: 281 / 608

Parameter Function assignment of external terminals
FR-E700 SC EC/ENE 6 - 127
You can set the functions of the output terminals.
Refer to the following table and set the parameters:
0–99: Source
logic
100–199: Sink logic
Setting
Terminal Function Operation Related Parameters
Refer to
Page
Source
Logic
Sink
Logic
0 100 RUN Inverter running
Output during operation when
the inverter output frequency
rises to or above Pr. 13 "Starting
frequency".
— 6-129
1 101 SU
Up to frequency
햲
Output when the output fre-
quency is reached to the set fre-
quency.
Pr. 41 6-131
3 103 OL Overload alarm
Output while stall prevention
function is activated.
Pr. 22, Pr. 23, Pr. 66 6-44
4 104 FU Output frequency detection
Output when the output
frequency reaches the
frequency setting in Pr. 42
(Pr. 43 for reverse rotation).
Pr. 42, Pr. 43 6-131
7 107 RBP Regenerative brake prealarm
Output when 85% of the regen-
erative brake duty set in Pr. 70 is
reached.
Pr. 70 6-103
8 108 THP
Electronic thermal O/L relay
pre-alarm
Output when the electronic
thermal relay function cumula-
tive value reaches 85%.
(Electronic thermal relay func-
tion protection (E.THT/E.THM)
activates, when the value
reached 100%.)
Pr. 9 6-86
11 111 RY Inverter operation ready
Output when the inverter can
be started by switching the
start signal on or while it is run-
ning.
— 6-129
12 112 Y12 Output current detection
Output when the output cur-
rent is higher than the Pr. 150
setting for longer than the time
set in Pr. 151.
Pr. 150, Pr. 151 6-133
13 113 Y13 Zero current detection
Output when the output power
is lower than the Pr. 152 setting
for longer than the time set in
Pr. 153.
Pr. 152, Pr. 153 6-133
14 114 FDN PID lower limit
Output when the feedback
value falls below the lower limit
of PID control.
Pr. 127–Pr. 134 6-293
15 115 FUP PID upper limit
Output when the feedback
value rises above the upper
limit of PID control.
16 116 RL
PID forward/reverse rotation
output Output when forward rotation
is performed in PID control.
20 120 BOF Brake opening request
Output to open the brake when
the brake sequence function is
selected.
Pr. 278–Pr. 283,
Pr. 292
6-111
25 125 FAN Fan fault output
Output at the time of a fan
fault.
Pr. 244 6-317
26 126 FIN Heatsink overheat prealarm
Output when the heatsink tem-
perature reaches about 85% of
the heatsink overheat protec-
tion providing temperature.
— 7-12
46 146 Y46
During deceleration at occurrence
of power failure (retained until
release) Output when the power failure-
time deceleration function is
executed.
Pr. 261 6-165
47 147 PID During PID control activated Output during PID control. Pr. 127–Pr. 134 6-293
64 164 Y64 During retry Output during retry processing. Pr. 65–Pr. 69 6-169
Tab. 6-31: Output terminal function assignment (1)