Mitsubishi Electric fr-e700 series, Instruction Manual

Page: 348 / 608

Misoperation prevention and parameter setting restriction Parameter
6 - 194
Restart (PS reset) method when PU stop (PS display) is made during PU operation
PU stop (PS display) is made when the motor is stopped from the unit where control command source
is not selected (operation panel, parameter unit (FR-PU04/FR-PU07, operation panel for FR-E500
(PA02)) in the PU operation mode.
For example, when Pr. 551 "PU mode operation command source selection" = 9999 (initial value), the
motor is stopped from the PU (PS display) if entered from the operation panel in PU operation mode
with the parameter unit mounted.
When the motor is stopped from the PU when the parameter unit (FR-PU04/FR-PU07) is select-
ed as control command source
햲
After the motor has decelerated to a stop, press the STOP/RESET key of the parameter unit
(FR-PU04/FR-PU07).
햳
Press the PU/EXT key to change to the external operation mode. The EXT indication is lit. The
message "PS" is cancelled.
햴
Press the PU key of the parameter unit (FR-PU04/FR-PU07) to select the PU operation mode.
햵
Press the FWD or the REV key of the parameter unit (FR-PU04/FR-PU07).
NOTE
When Pr. 551 = "9999", the priorities of the PU control source is USB connector > parameter unit
(FR-PU04/FR-PU07) > operation panel.
P
CAUTION:
Do not reset the inverter while the start signal is being input. Otherwise, the motor will start
instantly after resetting, leading to potentially hazardous conditions.