Add IP Solutions
Task List: Install TN2302AP
608
SI Installation and Upgrades
June 2004
3
On page 2, type in the node names and IP addresses for the TN799x and the TN2302AP.
NOTE:
The customer or design team provides the actual name and address. Suggest a generic
name and not one tied to the circuit pack.
4
Type
display circuit-pack
and press Enter. Verify that the TN2302AP shows up in the
Code
column.
5
Type
change ip-interfaces
and press Enter. See
Figure 237, IP Interfaces screen,
on page 609
NOTE:
The customer provides the IP address, subnet mask, and gateway address.
6
Type in the following information for the TN2302AP IP Media Processor and TN799x C-LAN:
— Set
Slot
field to UUCSS.
— The
Code
and
SFX
fields are automatically populated with TN799x and TN2302AP.
— In the
Node Name
field type the same node name entered on the Node Name screen.
— In the
Subnet Mask
field use the default setting unless you are given a different subnet
mask.
— In the
Gateway Address
field use the address you are given or leave blank.
— Set the
Net Region
field to 1 unless you are given a different number.
— Set the
Enable Eth Pt
field to y
7
Press Enter to save the information and effect the new settings.
Refer to the Administration for Network Connectivity for Avaya™ Communication Manager (555-233-
504) for more information on these administration steps and for the steps to administer IP Softphones and
H.323 trunks.
NOTE:
The administration of the TN2302AP is the same as that for the TN802B.
