Install Fiber Optic Cable Pass-Thru Kit for SCC1 (Single-Carrier) Cabinets
Install the fiber optic cable pass-thru kit (SCC1)
194
SI Installation and Upgrades
June 2004
Prepare the cabinet
Return to Task List
1
Verify the equipment received.
See
Figure 22, Fiber pass-thru kit equipment,
on page 195. Actual equipment may vary in
appearance and may ship in separate packages.
2
Remove the 2 perforated metal panels from the rear of the cabinet. See
Figure 23, Remove the
rear panels,
on page 196.
3
Remove the front door.
NOTE:
Administration may be required before removing the circuit pack in the following step.
4
Determine which slot (1 or 2) will contain the new fiber optic circuit pack. Remove the circuit
pack or the blanking plate from this slot.
NOTE:
For duplicated systems, you must install the duplication interface circuit pack in slot 1.
NOTE:
If a circuit pack is removed from the required slot, it must be installed into a different slot
in the cabinet. All translations associated with this circuit pack must also be moved.
5
Remove the circuit pack or the blanking plate from the slot next to the slot determined in
Step 4
.
Two consecutive open slots are required to install the fiber optic adapter.
NOTE:
If a circuit pack was removed in
Step 5
, it will be replaced into the same slot in the next
procedure.
6
From the rear, remove the I/O cable connector plate associated with the slot that will contain the
new fiber optic circuit pack.
7
Using a supplied cable tie, secure the removed I/O connector plate to the back of the cabinet or to
nearby cabling. This will keep it from moving loosely inside the cabinet.
8
From the rear, remove the I/O cable connector associated with the slot that will contain the new
fiber optic circuit pack. See
Figure 24, Remove the I/O cable connector,
on page 197.
9
Using a supplied cable tie, secure the removed I/O connector to nearby cabling. See
Figure 25,
Secure the I/O cable connector,
on page 198.
Return to Task List
