Install and Wire Telephones
Task List: Wiring Examples and Wiring Procedures
SI Installation and Upgrades
499
June 2004
Install and Wire Telephones
The wiring procedures are the same for most of the Avaya Media Gateway telephones and other
equipment.
This task list provides wiring examples of similar installation procedures. These are examples only;
actual wiring procedures may vary at each site.
After installing the hardware, the data for telephone features must be administered. These procedures are
provided in the Administrator’s Guide for Avaya Communication Manager (555-233-506).
NOTE:
Refer to the
Chapter , “Adjuncts and Peripherals”
to install the necessary peripheral
equipment.
Task List: Wiring Examples and Wiring Procedures
•
Voice and Data Terminals
on page 500
•
Analog Tie Trunk Example
on page 506
•
Digital Tie Trunk Example
on page 507
•
DS1 Tie Trunk Example
on page 508
•
Auxiliary Connector Outputs
on page 510
•
Three-Pair and Four-Pair Modularity
on page 514
•
Adjunct Power Connection Locations
on page 515
•
Attendant Console Example
on page 516
•
Connect External Alarm Indicators and Auxiliary Power
on page 519
•
Connect Power Distribution Unit External Alarm Wires
on page 520
•
Remote Network Interface
on page 523
•
Off-Premises or Out-of-Building Stations
on page 526
•
Emergency Transfer Units and Associated Telephones
on page 532
•
808A Emergency Transfer Panel and Telephone Installation Examples
on page 533
•
Install External Ringing
on page 544
•
Install the Queue Warning Indicator
on page 545
These links provide useful reference information:
•
Voice and Data Terminals
on page 500
•
Circuit Pack and Auxiliary Equipment Classifications
on page 567
•
Connector and Cable Diagrams (Pinout Charts)
on page 771
