Adjuncts and Peripherals
Multimedia call handling (MMCH)
814
SI Installation and Upgrades
June 2004
Administration
1
Enter
list configuration all,
and a list of the installed carriers, circuit packs, and ports appears.
2
Record the location (board number) of the new circuit packs and verify that all other required
circuit packs (refer to
ESM installation
) are present.
3
Enter
add DS1 xxxxx,
(where
xxxxx
is the location of the TN2207 PRI circuit pack recorded in
step 2), and the DS1 circuit pack administration form appears.
4
Set the
Name:
field to ESM DS1
5
Set the
Bit Rate:
field to 2.048
6
Set the
Line Coding:
field to hdb3
7
Set the
Signaling Mode:
field to isdn-pri
8
Set the
Connect:
field to pbx
9
Set the
Interface:
field to network
10
Set the
Country Protocol:
field
to 1
11
Set the
Protocol Version:
field to a
12
Set the
CRC?:
field to y
13
The
Idle Code
default is 11111111.
14
The
DCP/Analog Bearer Capability
default is 3.1 kHz.
15
Set the
MMI Cabling Board:
field to
xxxxx
(where xxxxx is the location of the
TN787F/H/J/K MMI circuit pack recorded in step 2). This must be the slot for port B of the Y-
cable.
16
The
MMI Interface:
field ESM
appears.
17
Enter
add signaling-group next
and the signaling-group form appears.
18
Change
Associated Signaling:
field to y
.
19
Change
Primary D-Channel Port:
field to
xxxx17 (where xxxx is the address of the
TN2207 PRI circuit pack, for example: 1B0517).
20
The
Max Number of NCA TSC:
default is
0.
21
The
Max Number of GA TSC:
default is
0.
22
Trunk Group for NCA TSC: ____
(leave blank)
23
Trunk Group for Channel Selection:____
(leave blank)
24
Logoff the terminal and then log back on the terminal to view your changes.
Place test call
Place multimedia data-conference call to an endpoint with known video capability to test the esm
function.
