R&S ZNC3, Руководство пользователя

Страница: 615 / 795

Command Reference
R&S
®
ZNC
599 User Manual 1173.9557.02 ─ 13
Suffix:
<Ch>
.
Channel number
Example: SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using default
settings.
SEGM OFF
Disable the measurement in the created sweep segment.
SEGM:COUN?
Query the number of segments.
Usage: Query only
Manual operation: See "Table Columns" on page 226
[SENSe<Ch>:]SEGMent<Seg>:DEFine <StartFreq>, <StopFreq>, <Points>, <Power>,
<SegmentTime>|<MeasDelay>, <Unused>, <MeasBandwidth>[, <LO>,
<Selectivity>]
Creates or re-defines a sweep segment no.
<Seg>
with specific channel settings.
Entry of the first seven numeric parameters is mandatory; no default values are provided.
All settings except
<LO>
can be changed for existing segments using other commands
of the
[SENSe<Ch>:]SEGMent<Seg>...
subsystem.
Note: Use
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
ADD
​
to create a segment with default chan-
nel settings. Use
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
INSert
​
(no query) to insert a new
segment into the current segment list.
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number. Segment numbers must be sequential.
The specified segment number must be smaller or equal to the
number of existing segments plus 1.
If segment number
<Seg>
already exists, it is replaced by the new
segment.
Parameters:
<StartFreq>
Start frequency of the segment; see
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
FREQuency:
​
STARt
​
.
Default unit: Hz
<StopFreq>
Stop frequency of the segment; see
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
FREQuency:
​
STOP
​
.
Default unit: Hz
<Points> Number of sweep points in the segment. See
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
SWEep:
​
POINts
​
.
<Power> Internal source power in the segment. See
​
[SENSe<Ch>:
​
]SEGMent<Seg>:
​
POWer[:
​
LEVel]
​
.
Default unit: dBm
SCPI Command Reference