Rohde & Schwarz ESW Series, User Manual

Page: 494 / 759

Remote Commands in the Receiver Application
R&S
®
ESW
494 User Manual 1177.6298.02 ─ 08
INPut<ip>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S ESW.
See the R&S ESW Getting Started manual for details.
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<State> ON | 1
User port is switched to INPut
OFF | 0
User port is switched to OUTPut
*RST:
1
Manual operation: See "User port configuration" on page 145
INPut<ip>:UPORt[:VALue]
This command queries the control lines of the user ports.
For details see
OUTPut<up>:UPORt[:VALue]
on page 494.
Suffix:
<ip>
.
1 | 2
irrelevant
Return values:
<Level> bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range:
#B00000000 to #B00111111
Example: INP:UPOR?
//Result: #B00100100
Pins 5 and 7 are active.
Manual operation: See "User port configuration" on page 145
OUTPut<up>:UPORt[:VALue] <Value>
This command sets the control lines of the user ports.
The assignment of the pin numbers to the bits is as follows:
Bit 7 6 5 4 3 2 1 0
Pin N/A N/A 5 3 4 7 6 2
Bits 7 and 6 are not assigned to pins and must always be 0.
The user port is written to with the given binary pattern.
Configuration