Rohde & Schwarz ESW Series, User Manual

Page: 139 / 759

Measurements and Result Displays
R&S
®
ESW
139 User Manual 1177.6298.02 ─ 08
– "Measurement Time" on page 100 (called "Acquisition Time" in the CISPR APD
application, but it is the same)
– "Scan Count" on page 113 (called "Sweep / Average Count" in the CISPR APD
application, but is the same)
●
Trace settings: are similar to those in the spectrum application.
Refer to the documentation of the spectrum application for a detailed description of
these parameters (including remote commands).
●
Trigger settings: are similar to those in the spectrum application (gated measure-
ments are not supported).
Refer to the documentation of the spectrum application for a detailed description of
these parameters (including remote commands).
●
General measurement settings: are similar to those in the receiver application.
–
"Measurement Bandwidth" on page 101 (called "Analysis BW" in the CISPR
APD application, but it is the same)
– "Measurement Time" on page 100 (called "Acquisition Time" in the CISPR APD
application, but it is the same)
– "Percent Marker" on page 139
●
Lines settings: are not available in the CISPR APD application.
●
Input source settings are similar to those in the receiver application.
See
Chapter 10.6.1, "Configuring the Input" , on page 148 for a detailed description
of these parameters (including remote commands).
●
External generator settings (optional): are similar to those available in the spectrum
application.
Refer to the documentation of the spectrum application for a detailed description of
these parameters (including remote commands).
●
Output settings: are similar to those available in the receiver application.
–
Chapter 10.6.4, "Configuring Outputs (IF / Video / Demodulation)" ,
on page 163
– Chapter 10.6.5, "Configuring LISNs" , on page 167
– Chapter 10.6.6, "Configuring Additional Outputs" , on page 167
●
Marker settings: are similar to those in the receiver application.
See
Chapter 11.4, "Marker Usage" , on page 226 for a detailed description of these
parameters (including remote commands).
●
Marker functions: are not available in the CISPR APD application.
Percent Marker ............................................................................................................139
Percent Marker
Defines a probability value. Thus, the power which is exceeded with a given probability
can be determined very easily. If marker 1 is deactivated, it is switched on automati-
cally.
Remote command:
CALCulate<n>:MARKer<m>:Y:PERCent
on page 482
CISPR APD Measurements