Rohde & Schwarz ESW Series, User Manual

Page: 147 / 759

Common Measurement Settings
R&S
®
ESW
147 User Manual 1177.6298.02 ─ 08
entire measurement channel from input over processing to output and analysis by
stepping through the dialog boxes as indicated in the "Overview".
To configure settings
► Select any button to open the corresponding dialog box.
● Input
● Amplitude
● Frequency
● Trigger
● Output
● Bandwidth
● Analysis
● Display Config
(For more information about the "Test Automation" button, see Chapter 9.3, "Test Auto-
mation" , on page 102.)
Preset Channel ........................................................................................................... 147
Specific Settings for .................................................................................................... 147
Preset Channel
Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to
restore all measurement settings
in the current channel to their default values.
Note that the [Preset] key restores the entire instrument to its default values and thus
closes
all channels on the R&S ESW (except for the default channel)!
See "Preset Mode" on page 339
Remote command:
SYSTem:PRESet:CHANnel[:EXEC]
on page 593
Specific Settings for
The channel may contain several windows for different results. Thus, the settings indi-
cated in the "Overview" and configured in the dialog boxes vary depending on the
selected window.
Select an active window from the "Specific Settings for" selection list that is displayed
in the "Overview" and in all window-specific configuration dialog boxes.
The "Overview" and dialog boxes are updated to indicate the settings for the selected
window.
When you select the "Bargraph" item from the dropdown menu, changes are also
applied to the scan. If settings are not available for the Bargraph (for example trace
settings), changes only apply to the scan. The same goes for numerical result displays
(for example the "Peak List").
Configuration Overview