Rohde & Schwarz ESW Series, User Manual

Page: 399 / 759

Network and Remote Operation
R&S
®
ESW
399 User Manual 1177.6298.02 ─ 08
Risk of network problems
All parameters can be edited here; however, beware that changing the computer name
has major effects in a network.
For details, see
Chapter 14.5, "How to Set Up a Network and Remote Control" ,
on page 409.
Network settings in secure user mode
Be sure to store all network settings before SecureUser Mode is enabled; see Chap-
ter 4.7, "Protecting Data Using the Secure User Mode" , on page 40.
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S
ESW in secure user mode, as the settings are not stored
permanently in this case.
Computer Name ..........................................................................................................399
IP Address ...................................................................................................................400
Subnet Mask ............................................................................................................... 400
DHCP .......................................................................................................................... 400
Network Configuration .................................................................................................400
Computer Name
Each instrument is delivered with an assigned computer name, but this name can be
changed. The naming conventions of Windows apply. If too many characters and/or
numbers are entered, an error message is displayed in the status line.
The default instrument name is a non-case-sensitive string with the following syntax:
<Type><variant>-<serial_number>
For example
ESW26-123456
The serial number can be found on the rear panel of the instrument. It is the third part
of the device ID printed on the bar code sticker:
Network and Remote Control Settings