Measurements and Result Displays
R&S
®
ESW
127
User Manual 1177.6298.02 ─ 08
9.3.4.2
Modifying a Peak List
Access
: "Overview" > "Test Automation" > "Peak List"
The peak list contains the frequencies on which the peak search has identified peaks.
It can be used as the basis of the final measurement.
Modifying a peak list (alternate way)
The R&S
ESW also provides an alternate way to modify a peak list.
Figure 9-13: Overview of the peak list
Reading the peak list
The table at the top of the dialog contains information when you measure with limit
lines. Each cell of the table represents a trace and shows the limit lines that are
assigned to that trace. In the screenshot above, for example, the limit line named
"Another One" is active and assigned to Trace
1.
The main table shows the following information for each peak in the peak list. The size
of the table depends on the number of peaks that have been found.
●
Trace / Detector
Shows the number of the trace and the detector used for that trace.
●
Frequency
Shows the frequency where the peak was found.
●
Level
Shows the absolute level value of the peak. The unit depends on the unit you have
selected.
●
Delta Limit
Shows the distance of the peak to the nearest limit line that has been assigned to
the corresponding trace. The distance is a value in dB. Available if you are using
limit lines.
●
Comment
Test Automation
