Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 87 / 813

R&S
®
ZVT Remote Control in a LAN
1300.0045.62 1.15 E-1
•
If the network supports dynamic TCP/IP configuration using the Dynamic Host Configuration
Protocol (DHCP), all address information can be assigned automatically.
•
If the network does not support DHCP, or if the analyzer is set to use alternate TCP/IP
configuration, the addresses must be set manually.
By default, the analyzer is configured to use dynamic TCP/IP configuration and obtain all address
information automatically. This means that it is safe to establish a physical connection to the LAN
without any previous analyzer configuration.
Attention!
If your network does not support DHCP, or if you choose to disable dynamic
TCP/IP configuration, you must assign valid address information
before connecting
the analyzer to the LAN. Contact your network administrator to obtain a valid IP
address, because connection errors can affect the entire network.
Manual TCP/IP configuration
To disable dynamic TCP/IP configuration and enter the TCP/IP address information manually proceed
as follows:
1. Obtain the IP address and subnet mask for the analyzer and the IP address for the local default
gateway from your network administrator. If needed, also obtain the name of your DNS domain
and the IP addresses of the DNS and WINS servers on your network. If you use both LAN
connectors, you need two different sets of address information.
2. Press the Windows key on the external keyboard or on the hardkey bar of the GUI to access
Windows XP Embedded (see section Connecting a Monitor on p. 1.12) .
3. Open the Control Panel – Network Connections – Local Area Connection Status – Local Area
Connection Properties – Internet Protocol (TCP/IP) Properties dialog and enter the address
information, e.g.:
For more information refer to the Windows XP Embedded Help.