Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 542 / 813

CALCulate R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.80 E-6
Example:
Suppose that the active setup contains two traces Trc1 and Trc2,
assigned to channels no. 1 and 2, respectively (see example for
CALCulate<Ch>:PARameter:SELect
).
:CALC1:PAR:SEL 'TRC1'; CALC1:MARK1 ON; MARK2 ON
Select Trc1 as the active trace and create the two markers no. 1 and 2.
The default position for both markers is the center of the sweep range.
CALC1:MARK:COUP ON
Create two markers no. 1 and 2 on Trc 2 and couple them to the
markers of Trc 1.
CALCulate<Ch/Tr>:MARKer<Mk>:DELTa[:STATe] <Boolean>
Switches the delta mode for marker <Mk> on trace no. <Ch/Tr> on or off. The marker must be created
before using
CALCulate<Ch/Tr>:MARKer<Mk>[:STATe] ON
. If the active trace contains no
reference marker, the command also creates a reference marker.
<Ch/Tr> Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10.
<Boolean> ON | OFF - Enables or disables the delta mode.
*RST value OFF
SCPI,
Command
Types Device-specific, command or query.
Example:
Suppose that the active setup contains an active trace no. 1 (see
example for
CALCulate<Ch>:PARameter:SELect
).
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and set
marker 1 to delta mode.
CALCulate<Ch/Tr>:MARKer<Mk>:FORMat MLINear | MLOGarithmic | PHASe |
POLar | COMPlex | GDELay | REAL | IMAGinary | SWR | LINPhase | LOGPhase |
IMPedance | ADMittance | MDB | MLPHase | MDPHase
Defines the output format for the (complex) value of marker <Mk> on trace no. <Ch/Tr>.
Note: The formats of the markers assigned to a trace are independent of each other and of the trace
format settings; see
CALCulate<Ch/Tr>:FORMat
.
<Ch/Tr> Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10.