Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 719 / 813

R&S
®
ZVA/ZVB/ZVT SENSe
1145.1084.12 6.257 E-6
Example:
SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using default
settings and thus 0 s meas. delay.
SEGM:SWE:DWELl 0.1
Increase the meas. delay to 0.1 s.
SEGM:SWE:DWELl:CONT OFF
Couple the meas. delay in all segments and reset the delay in segment
no. 1 to the initial value of 0 s.
[SENSe<Ch>:]SWEep...
This subsystem provides general settings to control the sweep . Most of the settings are related to the
sweep time.
Note: The [SENSe<Ch>:]SWEep... settings apply to non-segmented sweep types. Segmented sweeps
are selected via
[SENSe<Ch>:]SWEep:TPYE SEGMent
and configured in the
[SENSe<Ch>:]SEGMent<Seg>... subsystem.
[SENSe<Ch>:]SWEep:COUNt <No_of_Sweeps>
Defines the number of sweeps to be measured in single sweep mode (
INITiate<Ch>:CONTinuous
OFF
).
<Ch> Channel number. If unspecified the numeric suffix is set to 1.
<No_of_Sweeps> Number of consecutive sweeps to be measured.
Range [def. unit] 1 to 999. [–]
*RST value 1
SCPI, Command Types
Confirmed, command or query
Example:
See CALCulate<Ch/Tr>:DATA:NSWeep?.
[SENSe<Ch>:]SWEep:DETector:TIME <det_time>
Defines the detector observation time ratios and wave quantities if a Peak or RMS detector is active.
The detector is selected together with the measured quantity
(
CALCulate<Ch>:PARameter:MEASure
or
CALCulate<Ch>:PARameter:SDEFine
).
<Ch> Channel number.
<det_time> Detector time.
Range [def. unit] 0 s to 3456000 s. [s]
*RST value 0.01 s
SCPI, Command
Types Confirmed, command or query