Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 767 / 813

R&S
®
ZVA/ZVB/ZVT Program Examples
1145.1084.12 7.1 E-1
7 Program Examples
This chapter contains detailed program examples on the following subjects:
•
Traces, Channels and Diagram Areas
•
Calibration
The syntax and use of all SCPI commands is described in the SCPI Reference chapter. For a general
introduction to remote control of the analyzer refer to chapter Remote Control .
Traces
The following example shows you how to create and name channels, and assign traces to channels
and diagram areas.
// Reset the analyzer
*RST
//
// Delete channel 1
:CONFigure:CHANnel1 OFF
//
// Create channels 1 - 4 and traces on this channels
:CALCulate1:PARameter:SDEFine 'Trc1', 'S11'
:CALCulate2:PARameter:SDEFine 'Trc2', 'S12'
:CALCulate3:PARameter:SDEFine 'Trc3', 'S21'
:CALCulate4:PARameter:SDEFine 'Trc4', 'S22'
//
// Assign names to the channels
:CONFigure:CHANnel1:NAME 'Channel 1'
:CONFigure:CHANnel2:NAME 'Channel 2'
:CONFigure:CHANnel3:NAME 'Channel 3'
:CONFigure:CHANnel4:NAME 'Channel 4'
//
// Query channel names
:CONFigure:CHANnel1:NAME?
:CONFigure:CHANnel2:NAME?
:CONFigure:CHANnel3:NAME?
:CONFigure:CHANnel4:NAME?
//
// Get list of channel numbers and names (2 entries per channel)
:CONFigure:CHANnel:CATalog?