Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 618 / 813

FORMat... R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.156 E-6
Units for DISPlay... Commands
The DISPlay... subsystem contains commands to define particular points in the diagram, e.g. to set the
scale or a reference value. This requires the entry of a numeric value and a physical unit, depending on
the parameter type displayed. The following table lists the physical units accepted by the analyzer.
Power DBM, DB, DBW, W, MW, UW, NW, PW
Voltage
V, MV, UV, NV, PV, DBV, DBMV, DBUV
Phase
DEG, KDEG, MDEG, UDEG, NDEG, PDEG
Group delay
S, MS, US, NS, PS
Impedance
OHM, GOHM, MOHM, KOHM
Admittance
SIE, MSIE, USIE, NSIE
Inductance
H, MH, UH, NH, PH, FH
Capacitance
F, MF, UF, NF, PF, FF
Dimensionless
UNIT, MUNIT, UUNIT, NUNIT, PUNIT, FUNIT
FORMat...
This subsystem sets a data format for transferring numeric and array information from and to the
analyzer.
FORMat:BORDer NORMal | SWAPped
Controls whether binary data is transferred in normal or swapped byte order.
Parameters
NORMal – The least significant bit is transferred first (little
endian)
SWAPped – The most significant bit is transferred first (big
endian)
*RST value NORMal (if the GPIB Language is set to PNA, then the order is
SWAPped)
SCPI, Command
Types
Confirmed, command or query
Example:
FORM:BORD SWAP
Change the bit order to swapped mode.