Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 684 / 813

SENSe R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.222 E-6
*RST value The default frequency/frequency range corresponds to the sweep
range or CW frequency of the analyzer, i.e.
<numerator> = <denominator> = 1
<offset> = 0 Hz
Sweep type
Parameters SWEep – A frequency sweep is active, the command defines a
frequency range.
CW | FIXed – A power, time or
CW Mode sweeps is active, the
command defines a fixed frequency.
*RST value SWEep
SCPI, Command
Types Device-specific, command or query.
Example:
*RST; FREQ:STAR 1E+9; STOP 1.1E+9
Reset the analyzer (activating a frequency sweep) and set the
sweep range between 1 GHz and 1.1 GHz.
SENS:FREQ:CONV:ARB 2, 1, 1E+9, SWE
Convert the receiver frequency to the range between 3 GHz and
3.2 GHz.
[SENSe<Ch>:]FREQuency:CONVersion:AWReceiver[:STATe] <Boolean>
Qualifies whether a waves are measured at the source or at the receiver frequency. The setting is
relevant for all frequency-converting measurements.
<Ch>
Channel number.
<Boolean> OFF - Measurement at source frequency
ON - Measurement at receiver frequency
*RST value OFF
SCPI, Command Types Device-specific, command or query.
Example:
FREQ:CONV:AWR ON
Measure a waves at the receiver frequency.
[SENSe<Ch>:]FREQuency:CONVersion:HARMonic:ORDer <order>
Selects the order of the harmonic measured if a harmonic measurement is enabled
(
[SENSe<Ch>:]FREQuency:CONVersion HARMonic
).
<Ch> Channel number.
<order>
Order of the harmonic, integer multiple of the fundamental
frequency measured.
Range [def. unit] 2 to 100 [–].
*RST value 2
SCPI, Command
Types Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency:CONVersion