Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 774 / 813

Front Panel Connectors R&S
®
ZVA/ZVB/ZVT
1145.1084.12 8.2 E-3
Front Panel Connectors
Test Ports
N-connectors, numbered 1 to 4 (for four-port instruments). The test ports serve as outputs for the RF
stimulus signal and as inputs for the measured RF signals from the DUT (response signals).
•
With a single test port, it is possible to generate a stimulus signal and measure the response
signal in reflection.
•
With 2, 3 or 4 test ports, it is possible to perform full two-port, 3-port or 4-port measurements;
see S-Parameters section in Chapter 3.
Caution!
The maximum input levels at all test ports according to the front panel labeling or the
data sheet must not be exceeded.
In addition, the maximum input voltages of the other input connectors at the front and
rear panel must not be exceeded.
The three LEDs above each test port indicate the connector state:
•
The amber LED is on while the connector is used as a source port.
•
The green LED is on while the connector is used as a bidirectional (source and receive) port.
•
The blue LED is on while the connector is used as a receive port.
USB Connector
Double Universal Serial Bus connector of type A (master USB), used to connect e.g a keyboard, mouse
or other pointing devices, the Calibration Unit (accessory R&S ZV-Z51), a printer or an external storage
device (USB stick, CD-ROM drive etc.).
The length of passive connecting USB cables should not exceed 1 m. The maximum current per
USB port is 500 mA.