Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 604 / 813

DISPlay... R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.142 E-6
Example:
*RST; :DISP:WIND:TRAC:X:OFFS 1MHZ; :DISP:WIND:TRAC:Y:OFFS 10
Create the default trace and shift it horizontally by 1 MHz, vertically
by 10 dB.
DISP:WIND:TRAC:Y:OFFS?
Query all response offset values. The response is 10,0,0,0.
DISPlay:WINDow<Wnd>:TRACe<WndTr>:Y[:SCALe]:AUTO ONCE
Displays the entire trace <WndTr> in the diagram area, leaving an appropriate display margin.
<Wnd>
Number of an existing diagram area (defined by means of
DISPlay:WINDow<Wnd>:STATe ON
).
<WndTr> Existing trace number, assigned by means of
DISPlay:WINDow<Wnd>:TRACe<WndTr>:FEED
.
ONCE
Activate the autoscale function.
*RST value –
SCPI,
Command
Types
Confirmed, no query.
Example:
*RST; DISP:WIND:TRAC:Y:PDIV?; RLEV?
Query the value between two grid graticules and the reference value
for the default trace. The response is
10;0.
DISP:WIND:TRAC:Y:AUTO ONCE; PDIV?; RLEV?
Autoscale the default trace and query the scaling parameters again. In
general both values have changed.
DISPlay:WINDow<Wnd>:TRACe<WndTr>:Y[:SCALe]:PDIVision
<numeric_value>
Sets the value between two grid graticules (value “per division”) for a particular displayed trace. When a
new PDIVision value is entered, the current RLEVel is kept the same, while the top and bottom scaling
is adjusted for the new PDIVision value.
<Wnd> Number of an existing diagram area (defined by means of
DISPlay:WINDow<Wnd>:STATe ON
).
<WndTr> Existing trace number, assigned by means of
DISPlay:WINDow<Wnd>:TRACe<WndTr>:FEED
.
<numeric_value> Value and unit for the vertical diagram divisions.
Range [def. unit] Range and unit depend on the measured quantity, see Units for
DISPlay... Commands .
*RST value Depending on the measured quantity. The default reference level
for an S-parameter displayed in a
dB Mag diagram is 10 dB.