Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 706 / 813

SENSe R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.244 E-6
sweep time setting in the segment, which is equivalent to the
minimum sweep time possible.
<Point Delay>
Delay for each partial measurement in the segment. See
[SENSe<Ch>:]SEGMent<Seg>:SWEep:DWELl.
In the setting
[SENSe<Ch>:]SEGMent<Seg>:INSert:SELect SWTime,
this
parameter is replaced by <Time>.
Range [def. unit] 0 s to 2.5E+003 s. [s]
AUTO
activates automatic sweep time setting in
the segment, which is equivalent to a meas. delay of 0 s.
<Unused>
Ignored parameter, should be set to the default value 0.
<Meas.
Bandwidth> Resolution bandwidth in the segment. See
[SENSe<Ch>:]SEGMent<Seg>:BWIDth[:RESolution]
.
Range [def. unit] 1.0E-6 Hz to 5 MHz [Hz].
<LO>
Position of the local oscillator frequency LO relative to the RF
frequency
(Spur Avoid) . In remote control this parameter must be set
when a sweep segment is created.
Range [def. unit] POSitive: LO > RF
NEGative: LO < RF
<Selectivity> Selectivity of the IF filter. See
[SENSe<Ch>:]SEGMent<Seg>:BWIDth[:RESolution]:SELec
t
.
Range [def. unit] NORMal | HIGH [–]
SCPI, Command
Types Device-specific, with query (used to retrieve the channel settings for
a particular sweep segment).
Example:
SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using default
settings.
SEGM:DEF?
Query the channel settings for the new segment.
[SENSe<Ch>:]SEGMent<Seg>:DEFine:SELect SWTime | DWELl
Defines whether the sweep time of a new segment, i.e. numeric parameter no. 5 of the command
[SENSe<Ch>:]SEGMent<Seg>:DEFine
, is entered as a segment sweep time or as a meas. delay.
<Ch> Channel number 1.
<Seg> Sweep segment number.
SWTime Use segment sweep time.