Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 666 / 813

SENSe R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.204 E-6
Example:
CORR:COLL:METH REFL1
Select a one-port normalization at port 1 with an open standard as
calibration type.
CORR:COLL:SAVE:DEF
Calculate a dummy system error correction for the normalization at port
1. The dummy system error correction provides the reflection tracking
error term 'SCORR3'.
CORR:DATA? 'SCORR3'
Query the dummy system error correction term. The response is a 1
(written as 1,0 for the real and imaginary part) for each sweep point (no
attenuation and no phase shift between the analyzer and the calibration
plane).
CORR:DATA 'SCORR3',<ASCII_data>
Replace the dummy system error correction term with your own
correction data, transferred in ASCII format.
[SENSe<Ch>:]CORRection:COLLect:SAVE:SELected
Calculates the system error correction data from the acquired measurement results
(
[SENSe<Ch>:]CORRection:COLLect[:ACQuire]:SELected),
stores them and applies them to
the calibrated channel <Ch>. To avoid incompatibilities, older system error correction data is deleted
unless it has been transferred into a cal pool (
MMEMory:STORe:CORRection <Ch>,
'<file_name>').
<Ch> Channel number of the calibrated channel.
*RST value –
SCPI, Command
Types Confirmed, no query
Example:
CORR:COLL:METH:DEF 'Test',RSHort,1
Select a one-port normalization at port 1 with a short standard as
calibration type.
CORR:COLL:SEL SHOR,1
Measure a short standard connected to port 1 and store the
measurement results of this standard.
CORR:COLL:SAVE:SEL
Calculate the system error correction data and apply them to the
active channel.
[SENSe<Ch>:]CORRection:COLLect:SAVE:SELected:DEFault
Generates a set of default system error correction data for the selected ports and calibration type. The
default data set corresponds to a test setup which does not introduce any systematic errors; none of the
measurement results acquired previously
(
[SENSe<Ch>:]CORRection:COLLect[:ACQuire]:SELected)
is taken into account.