Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 49 / 813

R&S
®
ZVB Front Panel Tour
1145.1055.62 1.1 E-2
1 Preparing for Use
This chapter gives an overview of the front panel controls and connectors of the ZVB network analyzer
and gives all information that is necessary to put the instrument into operation and connect external
devices. Notes on reinstallation of the analyzer software appear at the end of the chapter.
Attention!
Please make sure to observe the instructions of the following sections so that
you cannot cause damage to the instrument or endanger people. This is of
particular importance when you use the instrument for the first time. Also
observe the general safety instructions at the beginning of this manual.
Chapter 2 of this manual provides an introduction to the operation of the analyzer by means of typical
configuration and measurement examples; for a description of the operating concept and an overview
of the instrument’s capabilities refer to Chapter 3.
For all reference information concerning manual and remote control of the instrument refer to the online
help system or its printed/printable version. A more detailed description of the hardware connectors and
interfaces is also part of the help system.
Front Panel Tour
The front panel of the network analyzer consists of the VGA display with the softkey area (left side), the
hardkey area (right side) and the test port area below. Brief explanations on the controls and
connectors, the hardkey area and the rear panel can be found on the next pages.