Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 746 / 813

STATus... R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.284 E-6
Note: If the stop power entered is greater than the current start power
(
SOURce<Ch>:POWer<Pt>:STARt
), the start power is set to the stop power minus the
minimum power span of 0.01 dB.
STATus...
This subsystem controls the Status Reporting System. Note that *RST does not influence the status
registers.
STATus:PRESet
Configures the status reporting system such that device-dependent events are reported at a higher
level.
The command affects only the transition filter registers, the ENABle registers, and queue enabling:
ƒ
The ENABle parts of the STATus:OPERation and STATus:QUEStionable... registers are set to
all 1's.
ƒ
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's, so that only
positive transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see Reset Values of the Status
Reporting System .
*RST value –
SCPI, Command Types Confirmed, no query
Example:
STAT:PRES
Preset the status registers.
STATus:QUEStionable:CONDition?
Returns the contents of the CONDition part of the QUEStionable register. Reading the CONDition
registers is nondestructive.
*RST value
–
SCPI, Command
Types Confirmed, query only
Example:
STAT:QUES:COND?
Query the CONDition part of the QUEStionable register to check
for questionable instrument states.