Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 672 / 813

SENSe R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.210 E-6
[SENSe<Ch>:]CORRection:EDELay<port_no>[:TIME] <delay>
Defines the offset parameter for test port <port_no> as a delay time.
<Ch> Channel number of the offset-corrected channel
<port_no> Port number of the analyzer
<delay> Delay
Range [def.
unit]
-3.40282346038 s to +3.40282346038 s. In contrast
to the electrical length
([SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth), the delay time
can not be incremented (the UP/DOWN parameters do not work).
*RST value 0 s [s]
SCPI,
Command
Types Device-specific, command or query
Example:
See [SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth
[SENSe<Ch>:]CORRection:OFFSet<port_no>[:STATe] <Boolean>
Resets the offset parameters for all test ports to zero or queries whether any of the offset parameters
are different from zero.
<Ch> Channel number of the offset-corrected channel
<port_no> Port number of the analyzer. This numeric suffix is ignored; the
command affects the parameters of all ports.
<Boolean> The parameter function depends on whether the command is used
as a setting command or as a query:
For setting command:
ON – no effect
OFF – resets all length offsets to zero
For query:
1 – at least one length offset is different from zero
0 – all length offsets are zero
*RST value OFF [–]
SCPI, Command
Types Device-specific, command or query
Example:
*RST; CORR:OFFS?
Reset the instrument and query whether the length offset
parameters have been reset as well. The response is
0 .
[SENSe<Ch>:]CORRection:POWer<port_no>...
This subsystem controls the receiver power calibration.