Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 551 / 813

R&S
®
ZVA/ZVB/ZVT CALCulate
1145.1084.12 6.89 E-6
CALCulate<Ch/Tr>:MARKer<Mk>:MODE CONTinuous | DISCrete
Sets marker no. <Mk> to continuous or discrete mode. The marker doesn't have to be created before
(
CALCulate<Ch/Tr>:MARKer<Mk>[:STATe] ON)
, the mode can be assigned in advance.
<Ch/Tr> Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10.
Parameters CONTinuous – marker can be positioned on any point of the trace,
and its response values are obtained by interpolation.
DISCrete – marker can be set to discrete
sweep points only.
*RST value CONT
SCPI,
Command
Types Device-specific, command or query.
Example:
Suppose that the active setup contains an active trace no. 1 (see
example for
CALCulate<Ch>:PARameter:SELect
).
CALC:MARK:MODE DISC; MARK2 CONT
Create marker 1 in discrete mode and marker 2 in continuous mode.
CALC:MARK ON; MARK2 ON
Display the two markers. Due to the different modes the horizontal
position can be different.
CALCulate<Ch/Tr>:MARKer<Mk>:REFerence[:STATe] <Boolean>
Creates the reference marker and assigns it to trace no. <Ch/Tr>.
<Ch/Tr> Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10. This numeric suffix is ignored and
may be set to any value.
<Boolean> ON | OFF - Creates or removes the marker.
*RST value OFF
SCPI,
Command
Types Device-specific, command or query.
Example:
Suppose that the active setup contains an active trace no. 1 (see
example for
CALCulate<Ch>:PARameter:SELect
).
CALC:MARK:REF ON; CALC:MARK ON
Create the reference marker and marker 1 and assign them to trace
no. 1. The default position of both markers is the center of the sweep
range.