NEC NEAX2400 ICS, Руководство по программированию

Страница: 474 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 431
Least Cost Routing - 3/6-Digit L-5
Programming (cont’d)
When assigning for SCC, each NXX is assigned as the following:
EFFECT:
0 = Restricted
EFFECT: 1 = Allowed
EFFECT: 2 = Not Used
Note: *When PFX, EFFECT = 1 is assigned. Add the required digit in the AADC command. OFFICE is the next
3 digits after those assigned in AFRS.
Example: AFRS RT31 = 91214 OPR1
ASDC checks next 3 digits: 91214 XXX XXXX
STEP 14: ATCP
- A maximum of eight Time-of-Day Pattern changes (0-7) are available, whereby the system
will refer to different OPR assignments as a function of time. As a result, different routes will be listed
per OPR and therefore different assignments in ASDC. Assign the following:
Times Setting
TO:
FROM: (In Military Time, and only on the half-hour and hour.)
PATTERN NUMBER: (0-7).
ARTI - (Assignment of Trunk Application Data) - Assign “DCAN (CDN: 54) = 1” for each route, that
may require connection establishment when a call is originated via LCRS with incomplete MND for
the AMND command.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
Note:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
STEP 1: ARTDN
- Assign the route class data for all the logical routes and dummy routes for LCR/LCRS.
6-TCL: 1,7-L/T: 1,8-RLP: 2,9-TQ: 1,13-AC:1
STEP 2: ANPDL/N - Assign the number of necessary digits for LCR/LCRS access. Usually assign DC=9,
NND=1.
STEP 3: ASPAL/N - Assign the LCR/LCRS (Least Cost Routing/Register Sender LCR) access code, Kind of
Service, SRV=LCR/LCRS. Assign Logical Route Number for Dummy Route associated with this
access code. Assign Connection Indexes, CI=N, H; Normal (N) and Hooking (H). Assign data “1” for
second dial tone, parameter (2nd). Assign data “1” to AH parameter if Procedure 2 is used for
AUTHORIZATION CODE [A-20].
STEP 4: ARNPL
- Assign access code for LCR/LCRS as assigned in ASPAL/N associated with the logical
routes for each external trunk assigned in ARTD/ARTDN, The LCR/LCRS access code is usually “9”.
The routes to be assigned will be those routes listed in the various OPRs of the AOPRL/N command.
Note: These same routes may also be listed in ASPAL/N for SRV=OGC (Outgoing Call). In that case, these routes
may also be available via direct dial access code. In ARNPL, these access codes are not assigned to
implement the LCRS service in this command.
STEP 5: ARSCN
- Assign the Route Restriction Class for all the Logical Route Number.
STEP 6: AFRSL/N
- Allocate the Dial Number necessary to determine the OPR used to select the routes.
Office