NEC NEAX2400 ICS, Руководство по программированию

Страница: 296 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 253
Call Return C-151
Operating Procedure (cont’d)
Manual Saving (equal to SAVE AND REPEAT - D
term
[S-24D]
1. Saving Calling Number
a.) Press the S&R key while in conversation using My Line or Sub Line.
b.) The received calling number is saved and the S&R key lights red.
Note: One calling number can be saved. When a calling number has already saved using SAVE AND REPEAT -
D
term
, the saved calling number is overwritten.
2. Displaying Stored Calling Number (for the D
term
with the S&R key)
a.) While in idle status, press the S&R key.
b.) The saved calling number is displayed for 5 seconds.
3. Call Origination
a.) Lift the handset and receive dial tone.
b.) Press the S&R key. The stored number is dialed.
Note: The dialed number is automatically deleted and the S&R key goes off.
Service Conditions
1. Service Conditions for Automatic/Manual Saving:
a.) The following circuit card is required for Analog Caller ID:
b.) Automatic/Manual Saving is available for the D
term
s assigned to the following ELC/DAI circuit
card.
c.) This service is not available when the calling number is not received.
d.) A maximum of 32 digits can be saved. However, when the calling number is received via CCIS
line, this feature is available for the first 16 digits (provided that “1” is assigned to 98: CI of
ARTD command).
e.) When a trunk access code (ex. “9”) is required for call origination to the saved number, the access
code must be added on a route basis by ACNP and ACND commands. Note that the added access
code is not displayed on the D
term
LCD. However, the added code is saved.
f.) When the area code is not to be sent to within the same area, the area code must be deleted by
AFRS, AOPR and AADC commands.
g.) When station data is changed by FOLLOW PHONE etc., stored number data is not exchanged.
h.) When the system is initialized, stored number data is deleted.
i.) When this service is used in an FCCS network, the system data should be set to all nodes.
However, when the calling number received from the remote FCCS node is not assigned
telephone number, the number of the calling station is not saved.
2. Service Conditions for Automatic Saving with the feature key / access code:
a.) Automatic Saving is available for analog stations allowed this service (ASFC, SFI 155 = 1) and
the D
term
with Call Return key.
CIRCUIT CARD NAME REMARKS
PA-8COTBJ
CIRCUIT CARD NAME REMARKS
PA-16ELCJ
PA-DAIJ (1.5M-AMI)