NEC NEAX2400 ICS, Руководство по программированию

Страница: 785 / 1089

NEAX2400 IPX Feature Programming Manual
Page 742
NDA-24297, Issue 1
T-3 TIE Line Access
Programming
STEP 1: ARTD - Assign the TIE Line routes as shown below:
BOTHWAY LINES:
RT: 1
1-OSGS
:2/7 2-ONSG :3 3-ISGS :2/7 4-INSG :3 5-TF :3
6-TCL :4 7-L/T :1 8-RLP :2 13-AC :1 15-LSG :5
28-ANS :1 30-PAD :7
STEP 2: ATRK - Assign the LENs, TIE Line Route Number, Trunk Number, and Tenant Number.
STEP 3: MBTK
- Assign the Make Idle status to the TIE Line trunks.
STEP 4: ANPD - Assign a number level for trunk access. Assign Connection Indexes, CI = N, H; Normal (N)
and Hooking (H). Number of Necessary Digits is usually 1 or 2. Busy Lamp Field is not activated.
STEP 5: ASPA - Assign the access code as assigned in ANPD above. Assign Connection Indexes, CI = N, H;
Normal (N) and Hooking (H). Type of Service, SRV = OGC (Outgoing Call), Outgoing Trunk. Assign
the route number associated with this access code.
STEP 6: ARSC
- The Route Restriction Class must be constructed to allow the station access to the involved
routes.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ARTDN - Assign the TIE Line routes as shown below:
BOTHWAY LINES:
RT: 1
1-OSGS
:2/7 2-ONSG :3 3-ISGS :2/7 4-INSG :3 5-TF :3
6-TCL :4 7-L/T :1 8-RLP :2 13-AC :1 15-LSG :5
28-ANS :1 30-PAD :7
STEP 2: ANPDL - Assign a number level for trunk access. Assign Connection Indexes, CI = N, H; Normal (N)
and Hooking (H). Number of Necessary Digits is usually 1 or 2. Busy Lamp Field is not activated.
STEP 3: ASPAL - Assign the access code as assigned in ANPD above. Assign Connection Indexes, CI = N, H;
Normal (N) and Hooking (H). Type of Service, SRV = OGC (Outgoing Call), Outgoing Trunk. Assign
the route number associated with this access code.
STEP 4: ARSCN
- The Route Restriction Class must be constructed to allow the station access to the involved
routes.