NEC NEAX2400 ICS, Руководство по программированию

Страница: 787 / 1089

NEAX2400 IPX Feature Programming Manual
Page 744
NDA-24297, Issue 1
T-5 TIE Line Connection With Pad Control
Programming (cont’d)
T: Tandem Connection
ICRT: Incoming Route Number
OGRT: Outgoing Route Number
SFC: Service Feature Class [Not Used]
IC PAD: Incoming PAD Data (1-15)
OG PAD: Outgoing PAD Data (1-15)
RT: Route Number [Not Used]
PAD DATA:
TLT (4W E&M)
DTI
0-8dB Pad On
1-2dB Pad On 1-2dB Pad On
2-4dB Pad On 2-4dB Pad On
3-6dB Pad On 3-6dB Pad On
4-8dB Pad On 4-8dB Pad On
15-PAD OFF 7-PAD OFF
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ARTDN
- Assign the TIE Line routes as shown below:
BOTHWAY LINES:
RT: 1
1-OSGS
:2 2-ONSG :3 3-ISGS :2 4-INSG :3 5-TF :3
6-TCL :4 7-L/T :1 8-RLP :2 15-LSG :5
Pad control is programmed in CDN 30:Pad. For DTI circuit cards, assign data “7”, otherwise assign
data “0”.
STEP 2: APADN
- Assign the Pad data required for the Tandem connection. Assign the following:
KIND: Kind of Connection
T: Tandem Connection
ICRT: Incoming Route Number
OGRT: Outgoing Route Number
SFC: Service Feature Class [Not Used]
IC PAD: Incoming PAD Data (1-15)
OG PAD: Outgoing PAD Data (1-15)
RT: Route Number [Not Used]
PAD DATA:
TLT (4W E&M)
DTI
0-8dB Pad On
1-2dB Pad On 1-2dB Pad On
2-4dB Pad On 2-4dB Pad On
3-6dB Pad On 3-6dB Pad On
4-8dB Pad On 4-8dB Pad On
15-PAD OFF 7-PAD OFF