NEC NEAX2400 ICS, Руководство по программированию

Страница: 669 / 1089

NEAX2400 IPX Feature Programming Manual
Page 626
NDA-24297, Issue 1
R-16 Radio Paging
Service Conditions (cont’d)
8. If the paging user has failed to hang up within a predetermined, programmable time interval (after
activation), the paging connection is forcibly released.
9. If the paged party does not answer within 30 seconds, the NEAX2400 IPX will automatically page that
party again. If the paged party does not answer the second page within 30 seconds, the paging request will
be cancelled from memory. (See VARIABLE TIMING PARAMETERS
[V-1] ).
10. Both the COT card and the TLT card can be used as the paging trunk.
11. Loop signaling is the recommended signaling type.
12. PAGING ACCESS [P-1], PAGING TRANSFER [P-10] and RADIO PAGING [R-16] are provided to the
paging station and the paged station in FCCS nodes.
13. When PAGING ACCESS [P-1]/PAGING TRANSFER [P-10]/RADIO PAGING [R-16] service is set to
a station in the remote node or the PAGING ACCESS [P-1]/PAGING TRANSFER [P-10]/RADIO
PAGING [R-16] call is answered from the remote node via FCCS link:
a.) the logical route number should be applied to each physical route that is provided the service.
b.) the restriction of route-to-route connection between FCCS nodes should be released.
14. The same paging route cannot be used by another station while the paged station does not answer the page
activated using the route. However, the paging activation is automatically cleared when the call is not
answered within a predetermined time.
15. A user can page one station at a time.
Interactions
1. If the range of the radio page transmitter exceeds the physical limits of the PBX, an incoming C.O. call
acting as a response to a Radio Page cannot be connected in loop-to-loop procedures. The paging party
must disconnect, and the Attendant must extend the paged party's C. O. call.
2. RADIO PAGING and PAGING ACCESS [P-1] can be provided simultaneously in the same system.
Separate access codes for each feature are required. A RADIO PAGING answer code is required for each
Radio Paging zone.
3. RADIO PAGING is limited to stations and Attendant Consoles. Other parties (C.O./TIE trunk calls) must
have the Attendant or user perform the paging operation.
4. The Attendant cannot dial the RADIO PAGING answer codes.
5. BUSY VERIFICATION [B-3], EXECUTIVE OVERRIDE [E-1]: These features will be denied when
connected to the Radio Paging route.
6. Radio Page Answer will not follow any hunting on forwarding that the paging station has set.
Programming
STEP 1: ASYD
- System Data 1, Index 73, Bit 2. Is the beeper number transmitted via the RADIO PAGING
equipment a two or three-digit number? 0/1: two digits/three digits.
System Data 1, Index 73, bit 4. Radio Paging - Station Number/Individual ATT Number is
automatically sent? 0/1: No/Yes.
System Data 1, Index 73, Bit 5. If the paged party doesn’t respond, should the system resend the
beeper number? 0/1: Yes/No. This also doubles the effective timing in System Data 1, Index 74, Bits
4-7.
System Data 1, Index 74, Bits 4-7. Recall timer for radio page. If the paged party does not respond by
the first time out, the paged party is called again and the time out is repeated.