NEC NEAX2400 ICS, Руководство по программированию

Страница: 512 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 469
Miscellaneous Trunk Restriction M-3
Programming
STEP 1: ASYD - System Data 2, Index 1, Bits 4 & 5. Should a restricted station be routed to the Attendant
Console or receive reorder tone?
Reorder Tone: Bit 4 = 0, Bit 5 = 0.
Attendant Console: Bit 4 = 1, Bit 5 = 0.
STEP 2: ARSC - Follow the procedure for [M-2] MISCELLANEOUS TRUNK ACCESS [M-2]. By assigning
the ARSC command, restrict RSCs from receiving certain routes. RRI 3: RES must be “2” if call
restriction to go to ATTCON. Then assign the restricted RSCs to stations via the ASDT or ASCL
command. When assigning the ARRC command, restrict incoming TIE lines from accessing certain
routes.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ARSCN - Follow the procedure for [M-2] MISCELLANEOUS TRUNK ACCESS [M-2]. By
assigning the ARSC command, restrict RSCs from receiving certain routes. RRI 3: RES must be “2” if
call restriction to go to ATTCON. Then assign the restricted RSCs to stations via the ASDT or ASCL
command. When assigning the ARRC command, restrict incoming TIE lines from accessing certain
routes.
Note:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.