NEC NEAX2400 ICS, Руководство по программированию

Страница: 282 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 239
Call Forwarding - I’m Here C-81
Service Conditions (cont’d)
12. When using the FCCS network, if the destination (target station) is a D
term
, CALL FORWARDING - I’M
HERE can be set or cancelled from a sub line of a D
term
. At that time, the transferred call terminates to the
My Line of the D
term
that sets the service.
13. When using the FCCS network, the service can be set or cancelled when the forwarding station is idle.
14. When using the FCCS network, the Service Conditions are the same between CALL FORWARDING -
DON’T ANSWER services to be set from the forwarding station and the target station (CALL
FORWARDING - I’M HERE).
15. When using the FCCS network, CALL FORWARDING - I’M HERE cannot be set from the ISDN
terminal (ISDN terminal cannot be the destination).
16. When using the FCCS network, CALL FORWARDING - I’M HERE can be set from the target station
(not ISDN terminal) toward the ISDN terminal (ISDN terminal can be a forwarding station).
17. When using the FCCS network, CALL FORWARDING - I’M HERE cannot be a set to the station that
has already set CALL FORWARDING - ALL CALLS (forwarding station). However, setting this service
to the station that operates the service (destination) is available.
18. When using the FCCS network, this service cannot be used with SPLIT CALL FORWARDING [S-99].
19. When using the FCCS network, CALL BACK [C-1, 1D] that is set to or from the forwarding station has
priority over CALL FORWARDING - I’M HERE (recall or answer call for CALL BACK is not the object
of CALL FORWARDING - I’M HERE).
20. When using the FCCS network, if this feature is set from the target station in the remote node within an
FCCS network, dial the telephone number for the forwarding station number.
21. When using the FCCS network, the telephone number must be assigned to the destination station also.
22. When using the FCCS network, the service restriction is decided by the ASFC data programmed to the
station that sets the service (destination station).
Programming
STEP 1:
Assign the CALL FORWARDING - ALL CALLS data. (See CALL FORWARDING - ALL CALLS
[C-5] .)
STEP 2: ANPD - Reserve a number level for feature access and cancel.
STEP 3: ASPA - Assign an access code to CALL FORWARDING - I’M HERE entry SID = 28. Assign to
CALL FORWARDING - I’M HERE cancel SID = 29. Assign Connection Status Index (CI) for
Normal (N) service.
STEP 4: ASFC
- Assign a Service Feature Class that allows SFI = 99 to the target stations, and SFI 100 to the
station to be set.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
SYS1, Index 4, b6. One Burst of Ringing On Call Forwarding (Call Forwarding) phone when Call
Forwarding - All Calls service has been assigned (analog phones only).
0/1 = Not Required/Required