NEC NEAX2400 ICS, Руководство по программированию

Страница: 1086 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 1043
Uniform Numbering Plan - CCIS U-5
Programming (cont’d)
STEP 9: AOPR - The AFRS command designates the dialing sequence and the OPR to be selected. The AOPR
defines the routes and in what order these routes will be selected. In this case, the DTI routes will be
assigned. Also, it may be desirable to include DDD trunks as an overflow. Assign the following
parameters:
TDC NO. - Time-of-Day Pattern Change. Usually, this parameter does NOT apply and data “0” must
be entered. However, if different OPRs will be required as a function of time for an AFRS assignment,
designate 1-7 for which Time-of-Day Pattern Change Number (TDC NO) this OPR is assigned.
OPR No. - Outgoing Pattern Route. The number referenced in AFRS, consisting of a series of routes to
be chosen based on number dialed.
Route Advance Number (RA) - The order in which a route will be selected (0-7). Usually only one or
two routes are involved with DTI Tie lines.
Route Advance End Display - The last route in the route advance group. Indicate with data “0”. All
other routes are indicated by data “1”.
Route Number - The physical Route Number to be selected, as programmed in ARTD.
Skip Digits - Do Not skip any digits. Usually the LCR access code is the opposite system’s station
level. This digit must be sent to the opposite PBX.
If dialing pattern 2 is being used from the final node, send only the two, three, or four-digit station
number before the node dialed.
Pattern Number Location - Digits to be added after translating the dialed digits in AFRS. Go to
AADC command. This is usually not applicable to the DTI trunks, but will be used for DDD overflow.
Add a 1 if required, and possibly the area code.
Overflow Tone - Assign if a tone is wanted for the Last Choice Route. If so, assign data “1” for DDD.
Assign the primary RSC as data “0”.
STEP 10: ARRC - Assign trunk-to-trunk connection capabilities between the various CCIS routes within each
node of the network. Assign for both Alternative Route Index ARI-D-RES, Direct Connection and
ARI-A-RES, via the Attendant Console. Assign RES: 1, allowed.
STEP 11: ARNP - For Pattern 2 dialing, route 0 must be used to assign the access code and an office code to this
office. This information is transmitted to the D
term
display at the other offices of the network.
Therefore, when an incoming call is received at a distant office, the called party will recognize which
office is originating the call. This information will also appear in characters 96-103 in the SMDR
output for an O/G call record. It is also required for MESSAGE REMINDER - CCIS [M-34].