NEC NEAX2400 ICS, Руководство по программированию

Страница: 613 / 1089

NEAX2400 IPX Feature Programming Manual
Page 570
NDA-24297, Issue 1
O-16 Outgoing Trunk Queuing - Attendant
Service Conditions (cont’d)
11. If data has not been cleared after the NCN is recovered, the call in the queue will be called back when a
trunk becomes idle status. If data has been cleared, the call is cancelled automatically.
Programming
STEP 1: ASYD - System Data 2, Index 4, Bit 2: Off-Hook OGQ for attendant 0/1: Out/In Service.
STEP 2: ASFC - Assign 1 (= Allowed) in SFI 21 (= Off-Hook OGQ) for SFC0.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ASYDN - This data must be assigned to the NCN.
System Data 1, Index 41: Designate the Trunk Queuing Override Timer
STEP 2: ASPAN
- These data must be assigned to the NCN.
TN: Tenant Number
ACC: Access number
CI: B = Busy (for Entry), N = Normal (for Cancel)
SRV: SSC
SID: 19 = OG Queuing-Entry
CI: N = Normal
SID: 20 = OG Queuing-Cancel
Note: The current data should also be set in addition the above-mentioned command.
The command to be set to the node accommodating the trunk: ARTD
The command to be set to all the nodes: ASYD, ASFC