NEC NEAX2400 ICS, Руководство по программированию

Страница: 746 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 703
Speed Calling - One Touch - D
term
S-26D
S-26D Speed Calling - One Touch - D
term
General Description
This feature allows D
term
users to dial telephone numbers by pressing a single key. Up to 12/24 numbers may be
programmed by the D
term
user.
Operating Procedure
To program
1. Press the FEATURE key.
2. Press the SPEED CALLING-ONE TOUCH button.
3. Dial the desired number.
4. Press the FEATURE key again.
5. Display will show SPEED SET.
Note: The page-change function works as follows: If the Page button is not lit, Page 0 Speed Dial memory is being
programmed. (This is the same memory that would be used if the Page feature were not being used.) To
program Page 1, press the FEATURE, the SPEED CALLING-ONE TOUCH button, the desired number,
and the FEATURE key again. Use of the Page feature allows twice the number of equipped speed buttons
to be used.
To verify
1. Press the FEATURE button and the desired SPEED CALLING - ONE TOUCH button: The first 16
characters will be displayed.
To use
1. Press the SPEED CALLING-ONE TOUCH button, the call will complete.
Service Conditions
1. A maximum of 16 SPEED CALLING - ONE TOUCH keys can be programmed to any key number (KYN)
in consecutive order, when using the appropriate firmware.
Note: 32 keys are available for the D
term
with a PAGE key (FKY = 55).
2. A stored number may have up to 32 digits, including access codes and pauses.
3. Only the first 16 digits are displayed on the LCD.
4. SPEED CALLING-ONE TOUCH numbers may only be stored while the D
term
is idle.
5. Storing a SPEED CALLING-ONE TOUCH number erases the previously stored number.
6. After dialing the new number, the user must press the SPEED CALLING-ONE TOUCH key before the
LCD displays the time. If the LCD displays the time before the user presses the key, the number has not
been stored. The LCD displays SPEED SET when the number has been stored.
7. Pressing the RECALL key while programming a SPEED CALLING-ONE TOUCH number inserts a
pause. A dash (“-”) is displayed on the LCD.
8. Pressing the RECALL key as the first digit of a SPEED CALLING-ONE TOUCH numbers inserts a flash
entry. A “!” is displayed on the LCD.
9. If a VOICE CALL-D
term
(V-2D) feature is programmed, VOICE CALL initiation can be programmed
onto a SPEED CALLING-ONE TOUCH key. The user dials the number and then presses the TRANSFER
key when programming SPEED CALLING. The LCD will display “V” after the number. Pressing the
SPEED CALLING-ONE TOUCH key initiates an automatic Voice Call to the programmed station.