NEC NEAX2400 ICS, Руководство по программированию

Страница: 624 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 581
Pushbutton Calling - Attendant Only P-5
P-5 Pushbutton Calling - Attendant Only
General Description
This feature permits an Attendant to place all calls over DTMF signaling lines from a pushbutton keypad on the
ATTENDANT CONSOLE [A-3].
Operating Procedure
Attendant presses the pushbutton keypad to dial.
Service Conditions
1. This feature requires that all Central Office trunks and TIE Trunk terminals accept pushbutton signaling
(DTMF).
2. PUSHBUTTON CALLING - ATTENDANT ONLY may be added to the system without providing
PUSHBUTTON CALLING [P-4] capability to other stations.
Interactions
The Attendant Console must first be provided.
Programming
STEP 1: ASYD - System Data 1, Index 128. Register Prepause Timer. How long the register waits for the first
digit. Normally assign data 00H for 12 seconds.
System Data 1, Index 134. Register Inter-digit Timer for the Attendant Console. How long the register
waits between digits. Normally assign data 00H for four seconds.
System Data 2, Index 2, Bit 1. Sender signal for Attendant Console is DP/PB? 0/1: DP/PB. Assign as
appropriate.
STEP 2: ATRK
- Assign Originating Register Trunks (ORT) to the Attendant Console (optional). Registers are
located on levels 0-3 of any 8RST circuit card.
Also, senders must be assigned to the system in a quantity calculated from expected traffic.
RT:
Route Number
Trunk Route Number
Intra-office Route Number (901-931)
901-ATT 912-ORT for ATT
902-ORT 913-TCFT for ATT
903-IRT 915- Night ATT
905-Sender 916-MFCR
909-DCFT 917-MFCS
919 to 926-Modem
TK: Trunk Number
TN: Tenant Number
RSC: Route Restriction Class
SFC: Service Feature Class
STEP 3: ARTD
- Routes must be assigned as either PB, DP, or DP/PB. CDN 2:ONSG, Type of Outgoing
Signal Selection, is assigned to each route as data “1”, DP; data “2”, PB; or data “3”, DP/PB.