NEC NEAX2400 ICS, Руководство по программированию

Страница: 685 / 1089

NEAX2400 IPX Feature Programming Manual
Page 642
NDA-24297, Issue 1
S-3 Speed Calling - System
S-3 Speed Calling - System
General Description
This feature allows a user or ATTENDANT CONSOLE [A-3] to call frequently dialed numbers using fewer digits
(abbreviated call codes) than would normally be required.
Operating Procedure
1. Lift handset; receive dial tone,
2. Dial SPEED CALLING - SYSTEM access code (maximum three digits), or press D
term
Speed Calling
key.
3. Dial abbreviated call code (maximum four digits).
4. Call is completed.
Service Conditions
1. SPEED CALLING - SYSTEM codes programmed into system data are accessible by all stations with a
CLASS OF SERVICE - INDIVIDUAL [C-15] permitting SPEED CALLING - SYSTEM.
2. Each abbreviated call code can store a maximum of 24 digits, including access codes and pauses.
3. SPEED CALLING - SYSTEM numbers are programmed via system data entry from the
MAINTENANCE ADMINISTRATION TERMINAL (MAT) [M-18].
4. Stations may be denied access to SPEED CALLING - SYSTEM via CLASS OF SERVICE [C-15]
assignment in system data. SPEED CALLING may also be allowed or denied on either a station or tenant-
wide basis.
5. TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may not
be applied to SPEED CALLING - SYSTEM, as desired.
6. LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING - SYSTEM access.
7. If the station is restricted from dialing outside via programming, the station can still access SPEED
CALLING - SYSTEM.
8. A maximum of 1,000 codes can be assigned per NEAX2400 IPX system.
9. The outgoing call using a trunk in the remote node is applied to this feature.
Interactions
1. FORCED ACCOUNT CODES [F-7] and AUTHORIZATION CODES [A-20] cannot be programmed for
use via the SPEED CALLING-SYSTEM.
2. Pauses are programmable from the MAT using the “P” key of the keyboard. Pauses consume one digit of
the available 24 digits. A pause lasts for 2.8 seconds. A pause cannot be added directly after an LCR access
code.
3. TOLL DIVERSION/TOLL DENIAL [T-6] and TOLL RESTRICTION 3/6 DIGIT [T-7] will interact with
this feature if SPEED CALLING-SYSTEM is toll restricted.
4. Special dial tone may be returned after dialing SPEED CALLING-SYSTEM if AUTHORIZATION
CODES [A-20] are operational in the system and Toll Restriction applies to SPEED CALLING-
SYSTEM.
5. See SPEED CALLING OVERRIDE-SYSTEM [S-61] .