NEC NEAX2400 ICS, Руководство по программированию

Страница: 855 / 1089

NEAX2400 IPX Feature Programming Manual
Page 812
NDA-24297, Issue 1
A-87 Automatic Number Identification (ANI) - CCIS
Service Conditions (cont’d)
Station number: 2xxx, 3xxx
The COC digits are 822 or 823; then assign ANI information.
Example 2:
Office number: 82, 826
Station number: 34xxx, 4xxx
The COC digits are 823 or 826; then assign ANI information.
10. After digits have been sent out, DDD seizure tone is not sent.
11. Other interactions are the same as those of outgoing call by MF signalling.
12. An 8RST-K circuit card is used for this service.
13. When a D
term
uses this feature, the calling number transmitted is that of the Prime Line.
Interactions
If “911” is to be exclusively used as an emergency number, then dial “9” access codes cannot be used solely for LCR
access. If “9-911” is used exclusively for an emergency call, then no numbering conflict will exist.
Programming
STEP 1: ARTD
- Assign Route:
RT: 1
1-OSGS
:7 2-ONSG :4 3-ISGN :7 4-INSG :4 5-TF :3
6-TCL :5 7-L/T :1 8-RLP :2 10-SMDR :1 13-AC :1
15-LSG :5 19-ANI :1 30-PAD :4 43-BT :1 82-RSAX :13
84-CSEG :15 70-TCMN :1
STEP 2: ATRK - Assign trunk LENs.
RT 905 TK1 LEN# (dependent on register location)
RT 905 TK2 LEN# (dependent on register location)
RT 904 TK1 LEN# (dependent on register location)
RT 904 TK2 LEN# (dependent on register location)
STEP 3: AAND
- Assign ANI data.
RT: 0
AT: 0 (0 = Station;1 = Individual-Attendant)
KT: 0 (0/1 = OFF/ON, expansion of station number lengths)
CC: 1 (0 = Main Central; 1 = Satellite Central)
COC: (Central Office Code, CCIS office code or first digit of CCIS remote station number. ARNP
RT0)
STNL: 0 (Number of digits in the caller’s number, assign 0)
SKIP: (Number of skip digits. Strips office code from being sent out in front of the station number.)
ADD: 3 (Number of digits to be added to the ANI information.)
DC: 753 (ANI sending number.)
Note:
The Office Code of the Central the first n digits of the Station Number to parameter COC should
not exceed five. Combinations of the COC and the first n digits of Station Number must be made in
conformity with the numbering plan of the remote office.
Basic LCR programming and route restrictions are required. Refer to LEAST-COST ROUTING-3/6 DIGIT
[L-5].
Programming for Enhanced 911 CCIS is only necessary at the main node.