NEC NEAX2400 ICS, Руководство по программированию

Страница: 1047 / 1089

NEAX2400 IPX Feature Programming Manual
Page 1004
NDA-24297, Issue 1
P-28 Paging Access - CCIS
P-28 Paging Access - CCIS
General Description
This feature provides dial access to paging equipment from an ATTENDANT CONSOLE [A-3] or station through
the CCIS network.
Operating Procedure
To access Paging through CCIS
1. Lift the handset and receive dial tone.
2. Dial the office code and the Paging access code.
3. Connection to paging equipment is established.
Service Conditions
1. Paging equipment must be provided by the customer.
2. One trunk circuit is required for each PAGING ACCESS.
3. If TENANT SERVICE [T-12] is provided, separate access codes and hardware should be provided for
each TENANT.
4. A maximum of three digits can be used for the PAGING ACCESS code.
5. The DIGITAL DISPLAY - TRUNK - CCIS [D-73] at the ATTENDANT CONSOLE [A-3] shows the
Route and Trunk Number of the CCIS trunk.
6. Following services are not available when this service is activated:
ALL ZONE PAGING [A-53]
MEET-ME PAGING [M-1]
PAGING TRANSFER [P-10]
Paging Answer
Interactions
1. MEET ME PAGING and PAGING ACCESS [P-1] can be provided simultaneously in the same system.
2. To directly answer PAGING ACCESS by the ATTENDANT CONSOLE [A-3], the Paged party should
use the INDIVIDUAL ATTENDANT ACCESS [I-4] feature.
3. Paging is limited to stations, ATTENDANT CONSOLES [A-3], or Tie Trunks. Other parties (CO trunk
calls) must have the ATTENDANT CONSOLE [A-3] or user perform the PAGING operation.
4. BUSY VERIFICATION [B-3], EXECUTIVE OVERRIDE [E-1] - These features will be denied if the
Paging route has been assigned for Privacy. Verify the data in the Assignment of Route Data command,
ARTD, CDN 44:PRV. If CDN 6:TCL is assigned as data “8”, CDN 44:PRV is not required.
5. For simple PAGE ACCESS, assignments in ASFC are not required. Refer directly to the other Paging
service features such as PAGING TRANSFER
[P-10] .
6. The ATTENDANT CONSOLE [A-3] can dial Priority Page access code and release a station.
7. When disconnecting from a Paging trunk, the trunk becomes idle immediately.
8. PAGING ACCESS is possible from CONSULTATION HOLD [C-17]. Therefore, Station A places party
B on Soft hold and dials the access code to the Paging Trunk. Another switch hook flash disconnects the
Page trunk immediately and reconnects party B to Station A.
9. CALL HOLD [C-6] - A Paging trunk cannot be placed on CALL HOLD.