NEC NEAX2400 ICS, Руководство по программированию

Страница: 63 / 1089

NEAX2400 IPX Feature Programming Manual
Page 20
NDA-24297, Issue 1
A-15 Announcement Service
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ALRTN - This data must be assigned to the NCN.
Assign the logical route number to the physical route.
STEP 2: AAEDN
- This data must be assigned to the NCN.
Assign the announcement equipment data.
UGN: User Group Number
EQP:
Announcement Equipment Number
0 = Dead Level
1 = Unused Number
2-15 = Announcement service
C: Duration of Connection
0 = Disconnection occurs in 30 seconds
1 = Connection is held until the station releases. See the requirements of the application for
the announcement equipment. For Dead level applications, data 0 is assigned.
R: Sending RBT
0/1 = Yes/No
A: Answer Signal Sending (Answer from the incoming trunk)
0 = No/Yes Normally assign data “1”.
M: Multiple Connection
0/1 = Single Connection/Multiple Connection
LGRT: Logical Route
TK:
Trunk Number *Not necessary for “M = 1”
STEP 3: ARRCN - This data must be assigned to the NCN.
Release the restriction between the terminating trunk and the announcement trunk.
STEP 4: ARSCN - This data must be assigned to the NCN.
Release the restriction between the announcement trunk and the station.
Note:
The current command data shown is set to all nodes using the service: ASTD, ARTD, ATRK, MBTK